I started building my first boat with expectations of turning it out in a weekend. but of course between the conception and the creation falls the shadow, and that shadow mostly consisted of scrounging for the right lumber and assorted pieces or waiting for UPS to deliver an order of epoxy and paint. While the construction was a great experience — especially planing things to fit with my beloved Lie-Nielsen pocket plane — I didn’t realize how long it would take to debug and adjust the boat to the point where it could be safely and easily rowed.
I built the boat for my daughter. She won the National High School Rowing championships in the coxed four event, went on to the Junior National Team, and eventually the women’s crew at the University of Virginia. I was surprised to see her post a picture of herself in the new boat on Instagram with the caption that it was her first row in a decade. Rowing is one of those sports that is very specific in terms of special equipment, and unless one joins a rowing club or buys a shell of their own, most rowers never pull an oar handle again unless its for an alumni row.
The trick in setting up a shell for sculling (when the rower has an oar in each hand) is finding the sweet spot in the boat to place the sliding seat and foot stretchers. Angus Rowboats has an excellent guide to sculling geometry, and entire books have been written about the science of rigging a shell, but I found the process to be one of patiently making incremental adjustments, setting the oarlocks a centimeter higher or lower, shifting the seat assembly aft towards the stern, everything clamped temporarily in place until that elusive sweet spot can be found before epoxying it all in place.
The leaks were easy to fix. I placed the boat on saw horses in a dark garage, bottom up, and slid a bright worklight under the boat, waving it around inside of the hull while I stood outside and looked for bright spots of light. I marked those with a piece of masking tape, flipped the boat upright, and coated the inside of the fabric hull with a skim coat of marine Goop — essentially rubber cement and silicone. Three coats of Interlux Sea Green boat paint on the exterior also sealed any open mesh in the polyester, and after three hunts of leaks I finally got the hull to the point where it barely leaks at all.
A small trailer was built from instructions on REI’s website for building a kayak caddy. A couple wheelbarrow wheels, two long lengths of schedule 40 3/4″ PVC, T-connectors, 45 and 90 degree joints, a poodle noodle filched from the back of the beach car, some glue and some straps, and now I can walk the boat down the hill to the bay every morning and get in a quick 5000 meters before sitting down for a day of work.
The boat rows extremely well in all conditions. One of the shakedown cruises was done in a 20 knot breeze and the boat handled the harbor chop beautifully. The hull tracks true and doesn’t hobby-horse over waves, slicing through them nicely. The run, or amount of glide between strokes, is less than a racing shell, but I can average five or six knots rowing at half-pressure.
Now that the rig is set, I can focus on cleaning up the boat and putting the finishing touches on it. I’m confident that I can row it year-round, especially if I’m careful when hypothermia is a threat and keep within swimming distance of the shore should the boat capsize or swamp. Winter is looking better by the minute.
